Configurator of CUTMaster cutting table
LOGIN
The CUTMaster configurator will help you choose the optimum set according to your needs.
1. First step it to choose table width. We propose four main sizes - 182, 202, 222, 242 cm. Table width should be a equal or bigger than the widest roll you cut from.
2. Second step is to choose the version of end cutter. The Standard version is moved manually, while the Super version offers automatic forward & back movement after pressing the start button. The main benefit of the automatic end cutter is speeding up work. Automatic end cutter in Super Plus version offers higher cutting capacity of single layer up to 2,5 cm
(in Standard and Super versions - 0,8 cm) and is recommended for thick materials.
3. Third step is the choice of the table length. Table is built in segments of about 1.5 m. When calculating the desired length you should take into account that spreading machine needs about 70 cm on the table top. Planning space in the cutting room, please remember to leave 80 cm in front of the table and 50 cm at the back.
4. Next step is to choose a holding bar. Basic version with parking brake is operated manually using a handle. Electric version is moved up and down by buttons, there is no need to use a brake as the holding bar is blocked after lifting until released.
5. Another option is a rotating bar of the spreader which makes it easy to quickly reverse the material side. It is very useful for fabrics with texture or patterns that are symmetrical to each match, such as the legs of trousers. Option not available in wider versions.
6. Smoothing roll smoothes the spreaded material resulting in wrinkles removal, especially on the knitted and lycra-type fabric, etc. Option not available in wider versions.
7. Bottom shelves are useful to store rolls of material and accessories needed in the cutting room, especially when you do not have a large space available. Table frame is prepared for adding bottom shelves at any moment, even if they are not ordered with the complete set.
8. Spreading board for pallets makes it easy to spread the material contained on the pallet. Just put a pallet on board and spread the material.
9. Power feed system should be chosen when there is no upper power feed system in the cutting room. We offer two types of power feed systems - bottom and upper.
10. Additional cones of bigger diameter will be useful for materials rolled on the thick tubes. Standard cones allow to mount tubes of diameter up to 45 mm.
© SAMEX 2017